Plastic bag filter housing is a filtration system which is produce with 100% PP (polypropylene )，PP bag filter housing is made of excellent PP material, can be used for filtering a lot of chemical sour soda liquids.
3, simple and safe: According to the user's filtration accuracy and the needs of different filter media, the user can choose different filter accuracy of the filter bag and plastic filter of different materials to achieve the quality of the filter needs; filter bag ring mouth
Plastic bag filter housing installation operation and maintenance:
Change the filter bag:
1, cut off the pump power and lock the pump power can not be turned on until the pump is running completely stopped.
2, close the filter inlet valve.
3, close the filter outlet valve.
4, open the drain valve, and then open the exhaust valve, the filter discharge liquid.
5, the filter should be no internal pressure.
6, check the pressure gauge pressure should be zero pounds.
7, additional external force Loosen the metal rings on the filter cover counterclockwise, 6 rings should be symmetrical loose, respectively, until the separation of the lid.
8, carefully remove the filter bag, insert the new filter bag.
9, the recommended pressure filter bag is 2 filter bag.
Install the plastic filter housing
1, with a small amount of lubricant to clean the o-ring gasket and O-ring gasket groove health.
2, the lid into place alignment, 6 rings and washers were placed in the top cover.
3. Manually and symmetrically tighten the metal lifting ring clockwise symmetrically, and then tighten the lifting ring symmetrically with the external force so that the lower end surface of the cover closely touches the upper end surface of the main body.
4, close the drain valve and exhaust valve.
5, open the outlet valve, and then open the inlet valve.
6, clean the outer surface of the filter, and do not scratch the outer surface.
7, Close the power, start the pump, check the lid seal for leakage and pressure gauge pointer is in the appropriate scale range.
ST402PPR FILTRATION SPEC:
Inlet & Outlet: 2.5” Flange
Filtration area: 0.5 m2
Flow rate: 45 m3/h
Design pressure: 10 bar
Suitable working pressure : 4-6 bar
Housing material: 304SS
Optional micron rate: 1um, 5um, 10um, 25um, 50um, 100um, 150um, 200um...600um...1000um
If you need other model, please contact us.
Filtration system application:
---Paints, Coating, Inks, Dispersions
---Water and Water Treatment
---Lubricants, Metalworking Fluids
---Parts Cleaning Solutions
---Pulp and Paper
---Potable Water, Beer, Wine
|Model||Max Flow(m3/h)||Max pressure||Max Temp||Pipe Size||Material|